The Basic steps – View Vinyl Cutter Specific Videos Below
- Place the roll on top of the stand rollers. For Heat-press vinyl, please flip the roll.
- Release the pinch rollers and release levers.
- Feed the vinyl underneath the pinch rollers (if working from a single sheet instead of a roll, the vinyl can also be fed from the front).
- Adjust the pinch rollers so there is one roller on each side of the vinyl (and, on models with 3 or more rollers, one roller near the centre). Avoid lowering a pinch roller to the gap between the two feed rollers.
- Leave a gap of between 12.7mm to 38.1mm from the edge of the roller and the edge of the vinyl on both sides.
- Engage the Pinch Rollers by pushing down on the Pinch Roller Release Levers.
- If the cutter is not already on, turn it on now.
